Thermo Scientific 180 Series, Operating And Maintenance Manual

Page: 18 / 36

Each bath is supplied with a thermometer and O-ring (packed separately).
The thermometer is attached to the bath via a metal clip on the top of the
bath.
Slip the O-ring onto the thermometer; insert this assembly through the
metal clip until the immersion depth indicator line is at or below the water
surface. The thermometer bulb should always be located above the diffuser
shelf.
Caution
Care should be taken to protect the thermometer from accidental
breakage and spillage of contents. The thermometer contains kerosene and
is not expected to be a health hazard in the normal intended use of the
thermometer.
s
Insert the line cord into the proper receptacle and turn the power switch
to the "ON" position. This action energizes the heater and causes the
amber pilot lamp to light. The pilot lamp will stay lighted as long as the
heater(s) is energized.
GP Water Baths 5-3 Thermo Scientific
Section 5
Operation
Bath Thermometer
Power ON
Off
0
On
1
2
10
0
10
9 1
8 2
9
8
5
4
3
4
6
7 3
6
7
5
Figure 5-2. Control Panel