![background image](http://html1.mh-extra.com/html/thermo-pride/cdx3-100n/cdx3-100n_installation-and-operation-manual_1104452049.webp)
All installations and services must be performed by qualified service personnel.
Figure 23:
b. Turn the inner plastic adjustment screw clockwise to increase, or counterclockwise to
decrease, the gas pressure (and gas flow) to the main burner.
c. Replace the regulator cover screw and tighten it firmly to prevent gas leakage.
d. Referring to Table 5, measure the gas pressure and to confirm it has been adjusted to within
the allowable range. Repeat adjustments (a) through (c), as required.
Table 5 Design Gas Pressures for each Furnace Model Series,
Operating Mode, and Type of Fuel.
Fuel Gas Type
Propane
Natural
Operating Mode and
Model Series
High Fire
CHX
Low
Fire
CDX
Low
Fire
High Fire
CHX
Low
Fire
CDX
Low
Fire
Normal Manifold
Pressure (in. W.G.)
10.0 ± 0.3 4.8 ± 0.3
5.6 ± 0.3
3.5 ± 0.3
1.8 ± 0.3
2.0 ± 0.3
Maximum Gas Supply
Pressure (in. W.G.)
14.0 14.0
Minimum Gas Supply
Pressure (in. W.G.)
11.0 4.5
13. Adjust the room thermostat so the burner will
operate on high fire only
.
14. To obtain an accurate manifold gas pressure reading, the main burner must be cycled on and off
several times to stabilize the gas control valve pressure regulator diaphragm.
15. Allow the burner to
operate for at least 3 minutes
before taking gas pressure readings.
16. Using a pressure gauge, measure the burner manifold gas pressure.
17. If checking the
input rate by measuring burner manifold pressure, proceed to step 18
. If
measuring the
input rate by clocking the gas meter, repeat steps 9 through 11, above
.
43