Thermo Neslab RTE 140, Instruction And Operation Manual

Page: 18 / 36

- 17 -
Program Control Program Control Program Control Program Control Program Control
The following tables show how to use the keypad and Main display to
program the controller. If an error message appears see page 20.
Use Table 1 to select one of the eight programs to be the current program for
either entering or running.
TABLE 1 TABLE 1
TABLE 1 TABLE 1
TABLE 1
Keypad input Main Display Comments
+/- Current bath temperature
-PROG/STORE 1 Pro Pro Pro Pro Pro followed by the Enter desired program
program number number.
-ENTER Current bath temperature
Once Table 1 is complete, use Table 2 for entering and storing a two-
setpoint program. You would follow this procedure for programming any
number of setpoints (up to the 16 setpoint maximum).
NOTE: NOTE:
NOTE: NOTE:
NOTE: The number of setpoints must be one greater than the number of
periods or you will get an error message.
TABLE 2 TABLE 2
TABLE 2 TABLE 2 TABLE 2
Keypad input Main Display Comments
-PROG/STORE - - - - - - - - - - - -
- - - - - - - - - - - -
- - - - - - If YES appears you should
clear the current program
(see Table 10).
-SETPT SP-1 SP-1 SP-1 SP-1 SP-1 Input setpoint.
-ENTER Desired setpoint
-PERIOD P-1 P-1 P-1 P-1 P-1 Input time in minutes.
-ENTER Desired time
-SETPT SP-2 SP-2 SP-2 SP-2 SP-2 Input setpoint.
-ENTER Desired setpoint
-LOOPS
LOOPS LOOPS
LOOPS LOOPS LOOPS Input number of loops
-ENTER Desired number of loops
-PROG/STORE FILE? FILE?
FILE? FILE?
FILE?
-ENTER Current bath temperature
Use Table 3 to abort programming at any time.
TABLE 3 TABLE 3
TABLE 3 TABLE 3
TABLE 3
Keypad input Main Display Comments
-ENTER - - - - - - - - - - - - - - - - - - - - - - - - -
-PROG/STORE FILE? FILE? FILE? FILE? FILE?
-CLEAR Current bath temperature
1. PROG/STORE must be depressed immediately (within one second) after +/-.