3
.
Figure 4
6. Ensure the top surface of the installation location is clean and free of any dirt. Suggested cleaners:
Isopropal alcohol, de-greaser. If needed, use a scouring pad to remove built-up oxides and residue.
Ensure all cleaning residue is removed and surface is dry and above 45 F / 1.3 C
(Figure 5)
.
Figure 5
7. Peel back the adhesive backing and apply the panel edge with the Junction Box near the outer edge
of the trailer to utilize any existing rivet strips for mechanical fastening and to minimize harness
routing on the top of the truck/trailer.
8. With the panel properly positioned, remove the remainder of the adhesive backing and firmly press
the panel down over the entire area. Ensure the entire panel is properly adhered to the surface. This
is critical to prevent moisture between the surfaces
(Figure 6)
.
Junction Boxes
Positive
Battery
Cable
w/Fuse
Negative
Battery
Cable
Charge Controller
(Install near the battery)
Extension Harness
Y-Harness
Solar Panels
