![background image](http://html1.mh-extra.com/html/thermo-king/098203/098203_maintenance-manual_1104405102.webp)
Main Menu
100
Alarm/Warning List Menu
Figure 87: Alarms Menu
View the Alarm/Warning List Menu
The Alarm/Warning list menu displays the code conditions. Alarm/Warning codes are recorded in the
controller memory to simplify unit diagnosis procedures. Some alarm codes are only recorded during a
Pretrip (PTI) test or function test. Fault codes are retained by the controller in a non-volatile memory. If
the Red LED is on or flashing, enter the alarm list to view the alarm.
With the unit turned on, allow unit to start and stabilize and the Display showing the unit status display
(setpoint):
1. Press the
F1
key to directly enter Alarms/Warning menu. The first alarm code number, alarm state
and alarm description appears in Display.
NOTE: Alarm codes are displayed in sequential order, not in order of occurrence.
2. Write down the first code. Then press the
F2
or F3 Up/Down
key to view next alarm code when more
than one code has been recorded.
3. Repeat above step until all alarm codes have been recorded. Press the
F2
key to scroll backward to
return to a previous code.
4. To clear all alarm codes from the current display list and turn off the Alarm LED, all problems must
be corrected and the alarm code “acknowledged” in the Alarm List menu.
5. To acknowledge an alarm/warning, press
F4 A
CCEPT
KEY
while code appears on screen. The alarm
state will change from Active or Not Active to Acknowledge. If no key is pressed for 30 seconds, the
controller returns to previous menu level or Unit status display
SETPOINT/CONTROL
Alarm List/Warning List
• View and write down
all alarm/warning code.
• Press F2 key to view
the next alarm/warning
code
• Clear alarm/warning
code by correcting
problem and
acknowledging the
alarm.
• To acknowledge an
alarm, press F4 key with
alarm code in display.
DATA
ALARM LIST
WARNING LIST
CONFIGURATION
DATALOGGER
STATES
NOTE: All screens are NOT
present on all units. The
screens that display on the
controller are determined by
the Controller Software
settings and the options
installed on the unit.
Summary of Contents for 098203
