Thermaltake ARGENT H5 RGB, Quick Installation Manual

Page: 27 / 28

FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
§
Increase the separation between the equipment and receiver.
§
Connect the equipment into an outlet on a circuit different from that to which the receiver is
§
connected.
Consult the dealer or an experienced radio/TV technician for help.
§
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
RADIATION EXPOSURE STATEMENT
The product comply with the FCC portable RF exposure limit set forth for an uncontrolled environment
and are safe for intended operation as described in this manual. The further RF exposure reduction
can be achieved if the product can be kept as far as possible from the user body or set the device to
lower output power if such function is available.
The marking information is located at the bottom of apparatus.
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
功 射 電 技 規範 ( 1090701)
取得 驗 明 功 射 材， ， 司、 或使 用者 不得 自 更 、加大功 或 更原
特性 功 。 功 射 材 使用不得 干擾合 ； 現有干擾現 時，
用，並 干擾時 得 使用。前 合 ，指 電 理 規 作業 電 。 功
射 材須 受合 或工業、科學 療用電波輻射性電 干擾。