user’s manual.
o
The equipment has been dropped and damaged.
o
The equipment has obvious signs of breakage.
Do not leave this equipment in an uncontrolled environment where the storage
temperature is below -20° C (-4°F) or above 60° C (140° F). It may damage the
equipment.
CAUTION
– Use the recommended mounting apparatus to avoid risk of injury.
WARNING
– Only use the connection cords that come with the product. When in
doubt, please contact the manufacturer.
WARNING
– Ground against electrostatic damage to the device by taking the
following preventive steps:
o
Cover workstations with approved anti-static material. Use a wrist strap connected
to a work surface and properly grounded tools and equipment.
o
Use anti-static mats, heel straps, or air ionizer for added protection.
o
Handle electrostatic-sensitive components, PCB’s and assemblies by the case or
the edge of the board.
o
Avoid contact with pins, leads, or circuitry.
o
Turn off power and input signals before inserting and removing connectors or test
equipment.
o
Keep the work area free of non-conductive materials, such as ordinary plastic
assembly aids and Styrofoam.
o
Use filed service tools, such as cutters, screwdrivers, and vacuum cleaners that are
conductive.
o
Always lay drivers and PCB’s with the component side down on anti-static foam.
Important Information
Federal Communications Commission Radio Frequency Interface Statement – For USA
This device complies with part 15 FCC rules. Operation is subject to
the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a class "A"
digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at him own expense.
