Thermal Solutions AMP 1000, Installation, Operation And Maintenance Manual

Page: 22 / 88

22
NOTICE NOTICE
Use of cellular core PVC (ASTM F891), cellular core CPVC, or Radel®
(polyphenylsulfone) in non-metallic venting systems is prohibited.
Covering non-metallic vent pipe and fittings with thermal insulation is
prohibited.
Vent & Intake
Materials
Vent
Option
Penetration
Through Structure
Termination Parts Table Reference
Figure
Two Pipe
Stainless Steel vent,
Galvanized Steel or
PVC intake
1
Intake Horizontal Sidewall Tee or elbow
Table 13
Figure 8
Vent Horizontal Sidewall Tee or straight
2
Intake Horizontal Sidewall Tee or elbow
-
Vent Vertical Roof Tee or straight
3
Intake Vertical Roof Tee or 2 elbows
Figure 9
Vent Vertical Roof Tee or straight
Two Pipe
Polypropylene vent,
Galvanized Steel or
PVC intake
4
Intake Horizontal Sidewall Tee
Table 14
Table 15
Figure 8
Vent Horizontal Sidewall Tee or straight
5
Intake Horizontal Sidewall Tee
-
Vent Vertical Roof Tee or straight
6
Intake Vertical Roof Tee or 2 elbows
Figure 9
Vent Vertical Roof Tee or straight
Two Pipe
CPVC vent,
Galvanized Steel or
PVC intake
7
Intake Horizontal Sidewall Tee or elbow
-
Figure 8
Vent Horizontal Sidewall Tee or straight
8
Intake Horizontal Sidewall Tee or elbow
-
Vent Vertical Roof Tee or straight
9
Intake Vertical Roof Tee or 2 elbows
Figure 9
Vent Vertical Roof Tee or straight
Room air for
combustion;
SS, PP,
or CPVC vent
10 Vent Horizontal Sidewall Tee or straight
Table 13
Table 15
-
11 Vent Vertical Roof Tee or straight
Notes:
1. It is recommended by the manufacturer to use tees for both intake and vent terminations.
2. All elbows being refereed to are 900 elbows.
3. All terminations shall have bird screens.
4. All non-metallic venting exposed to sunlight shall be UV resistant.
Table 9: Recommended Venting Configurations and Material Options
VII . Venting
(continued)