Thermadyne Fabricator 252i US Assembly Instructions Download Page 2

Page: 2 / 2

CONTROL PCB REPLACEMENT INSTRUCTIONS

4. Tilt panel toward you and disconnect the Ribbon Cable by flipping the two locking tabs outward then lifting

the harness connector from the board.

Art # A-10???

Figure 2: Control PCB Access

5. Remove the control panel assembly and replace with the new one by reversing these procedures.

6. Locate the new Control Panel PCB Assembly and orient it like the one just removed and attach the ribbon

cable making sure it snaps into place with both locking tabs being activated.

7. Carefully set the control panel assembly back into the front panel and secure with the four screws.

8. Apply power to the unit and verify the control panel is working.

NOTE

Any information/calibrations previously stored are now gone. All information is now factory default

and any desired calibrations will need to be done again.

www.thermadyne.com

Printed in Mexico

U.S. Customer Care: 800-426-1888 /

FAX

800-535-0557

•

Canada Customer Care: 905-827-4515 /

FAX

800-588-1714

www.thermal-dynamics.com

International Customer Care: 940-381-1212 /

FAX

940-483-8178

A Global Cutting & Welding Market Leader

™

Summary of Contents for Fabricator 252i US

Page 1: ...onnect power from the power supply 2 Locate the anti static strap in this kit and follow instructions for proper use and fit it to your body 3 Remove four 4 Control Panel screws 1 1 Art A 1 Figure 1 F...

Page 2: ...ce with both locking tabs being activated 7 Carefully set the control panel assembly back into the front panel and secure with the four screws 8 Apply power to the unit and verify the control panel is...