Service Manual for the Thermador Professional Series Rangetop, Model PCG366G
58300000151625_ARA_EN_B
Page 21 of 34
8. Now remove the manifold support brackets by removing and
retaining the following screws with a T-20 driver:
■ The two screws holding the manifold support bracket onto the
chassis base near the regulator (see Figure 26)
■ The two screws from each bezel of the two knobs connected
to the manifold support brackets (see Figure 24 and Figure 25)
to remove the manifold support brackets (see Figure 27).
9. After removing all brackets, gently lift the manifold out, being
careful of the wires and harnesses and other components.
Gas Leaks
Carefully check for gas leaks at each gas component that was
removed, replaced, or otherwise serviced using a gas leak detector or
bubble test.
Figure 25: Manifold Support Bracket Screws on Bezel
Figure 26: Manifold Support Bracket on Chassis Base
Figure 27: Manifold Support Bracket on Back of Control Panel
