P
AGE
6
STEP 2: Cabinet Preparation
Fig. 5 Side View of Cooktop
Fig. 7
Flush to Cabinet
Front
Front flush with cabinets; minimum
of 25-3/8" cabinet depth required.
* Provide clearance for screws by in-
creasing cutout height by 1/16" or by
notching in the location of the three
screws.
Fig. 6
Projecting from
Cabinet Front
Front projects outward 1-3/8" as
shown from standard 24”-deep base.
1-3/8"
5/8" Notch
Depth
*
Low Back required when there is less than
12" horizontal clearance from back of cooktop to
combustible material. With more than 12" of
clearance, the Island Trim may be used.
2" Notch
Depth
26-3/8"
22-5/8"
23-3/8"
2"
3/4"
7-3/4"
12"
1/2"
Countertop
3" TO CENTERLINE GAS INLET
Cabinet face for installation with projecting control panel
Cabinet face for installation with flush control panel
3"
Side View
7
-13
/
16
"
(198mm)
Plywood support
Install additional
wood support along
front edge of cutout
REAR
2 3/4" (70 mm) minimum
between cutouts
➛
➛
Fig. 8 Installation of 48" Cooktop above two
side-by-side Thermador Warming Drawers,
Model No. WD24N.
22 1/2"
(572 mm)
22 11/16"
(576 mm)
46 1/4"
(1175 mm)
22 1/2"
(572 mm)
7 13/16" (198 mm)
WD24Q
Cutout
WD24Q
Cutout
13/16"
(21 mm)
2 3/4" (70 mm) Vertical Distance
Between Cutouts
(See Side View for Wood Support)
1 7/8" (48 mm)
Horizontal Distance Between Cutouts
Minimum 3/4" (19 mm)
0" to 2"
(0 - 51mm)
(See Fig. 4
and Table
Dimension ”C”)
(229 mm) 9"
