Service Manual for the Thermador Pro Harmony Range, Model PRL364GDH/01
58300000154022_ARA_EN_D
Page 23 of 68
4. Remove support brackets (see Figure 30) by lifting the pins out of
the slots on the element tray.
5. Remove the thermostat bulb by carefully pulling it out of the
retaining bracket (see Figure 32)
NOTE:
After removing the thermostat bulb from retaining bracket,
do not push the bulb through the receptacle in the element tray
yet.
6. Disconnect the male-female ¼ inch spade connectors of both
(right and left) element wires. You may have to pull the element
wires out a bit to access the connectors
– while doing this, be
careful not to damage the element wires.
Figure 30: Support Bracket
Figure 31: Removing 2 Screws from Support Bracket
Figure 32: Removing the Thermostat Bulb from Retaining Bracket