Service Manual for the Thermador Pro Harmony Range, Model PRL364GDH/01
58300000154022_ARA_EN_D
Page 20 of 68
5. While lifting the brass burner base, carefully depress the locking
tab on the female terminal of the igniter wire, and gently pull to
detach from the electrode (see Figure 22 and Figure 23).
Figure 22: Igniter Wire Attached to Electrode
Figure 23: Igniter Wire Locking Tab
6. If the electrode needs replacing, remove and retain the small T-10
screw to detach it from the brass burner base. If not, leave it
attached to the brass burner base.
7. Remove and retain the T-30 screw holding the cast iron pedestal
burner to the maintop.
8. Remove the pedestal burner with the Venturi tube still attached to
it, while gently pulling the ignition wire through (see Figure 24).
-OR-
Alternatively, you can first lift the Venturi tube out from the
pedestal burner, before removing the pedestal burner from the
maintop.
Figure 24: Pedestal Burner with Venturi Tube
Press tab
to detach
from
electrode