Service Manual for Thermador Pro Grand LP Gas Ranges, Models: PRL304EG, PRL364EDG, PRL364ELG, PRL366EG, PRL484ECG, PRL486EDG, PRL486EDPG, PRL484ELG
58300000156573_ARA_EN_B
Page 61 of 119
Figure 112: Control Board for Small Oven
4.5.18 Simmer Control Board Removal and Replacement
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
1. Follow all safety precautions and steps in
.
2. Follow all steps in
Accessing Components under the Maintop
.
3. If obstructing access to the simmer control board, remove the
burner support rail (with jet holder assemblies attached) by
following the steps in
Removing the Burner Support Rail
, page
.
4. Remove and retain the screw to detach the ground wire from the
chassis (see Figure 113).
m
Caution
Fragile Components
Be careful not to exert too much pressure on the standoffs or the
simmer control board, as these are fragile components.
5. Using a needle nose pliers, disengage the control board from all
the plastic standoffs by lightly pressing the tiny protruding clip on
each standoff, while simultaneously pulling the simmer board off
the standoff (see Figure 113).
6.
Remove and replace the simmer control board if needed.
NOTE: Please explore other possible causes before
replacing the simmer control board. Approximately 75%
of all simmer control boards returned to the factory turn
out to be ok.
Figure 113: Simmer Control Board
1
Multi-pin wire connectors (2)
2 Standoffs
(4)
3
Ground wire (shown attached to screw on chassis)
