THERMACUT EX-TRAFIRE 40SD, Operator'S Manual

Page: 24 / 72

EX-TRAFIRE
®
40SD
Operator Manual, Revision T-15 3-24
Gas supply installation
Connect the air-line hose as follows:
Alignment of the machine torch FHT-EX
®
40M
Mount the machine torch perpendicular to the material to be cut, use a square to align the torch
at 0 ° and 90 °, if torch alignment is not possible, check the cutting table for level to obtain a true
vertical cut�
1� Air-line hose connection�
•
Female G1/4” thread adapter�
2� Air-line hose�
•
Use an inert gas hose with a minimum
internal diameter of 6 mm, make
a direct attachment or use a quick
disconnect fitting�