THERMACUT EX-TRAFIRE 30H, Operator'S Manual

Page: 17 / 56

EX-TRAFIRE
®
30H
Operator Manual, Revision T-15 3-17
Use of an alternative mains power lead is at the discretion of the user� The mains power lead shall
comply with local and national codes of practice� The mains power lead should be installed by a
certified electrician� See the length requirements listed in the table�
Recommended mains power lead extension
Input voltage Recommended wire cross-section Length
220 - 240 VAC /1 phase
2�5 mm
2
Up to 40m
Note: The system was tested with a 3 meter mains power lead for compliance with EMC standards�
Single-phase mains power lead
CE models are fitted with a 3 wire 2�5 mm
2
mains power lead� To operate the EX-TRAFIRE
®
30H,
use a plug that complies with national and local codes of practice� A certified electrician or
electrotechnically competent person should connect the mains power lead to the plug�
Installation of single-phase mains power lead
Plug type E (CEE 7/7)
The power supply cable connection
A certified electrician or electrotechnically competent person should connect the mains power lead
to a plug or hard wire to a suitable supply according to national standards�
Plug Type I AS-NZS 3112