51000 Series
1. Scan this QR code to watch a video tutorial.
2. You will need a Phillips head screwdriver
driver and a replacement EEC (Electrical
Enclosure Cover).
4. There will be (4) bolts on the front and (1)
in the rear.
3. Unplug the center module and remove
from Big Dipper tank.
6. Lift the skimming wheel cover and start
prying open the EEC cover. Pull upwards
until EEC is completely removed from
center module.
5. Use a Phillips head screwdriver and turn
counterclockwise to remove (5) bolts. Set
bolts aside.
Thermaco, Inc. • 646 Greensboro St. • Asheboro, N. C. 27204-2548 • Phone (336) 629-4651
51000 Series
1. Scan this QR code to watch a video tutorial.
2. You will need a Phillips head screwdriver
driver and a replacement EEC (Electrical
Enclosure Cover).
4. There will be (4) bolts on the front and (1)
in the rear.
3. Unplug the center module and remove
from Big Dipper tank.
6. Lift the skimming wheel cover and start
prying open the EEC cover. Pull upwards
until EEC is completely removed from
center module.
5. Use a Phillips head screwdriver and turn
counterclockwise to remove (5) bolts. Set
bolts aside.
Thermaco, Inc. • 646 Greensboro St. • Asheboro, N. C. 27204-2548 • Phone (336) 629-4651
Replacing the Printed Circuit Board PCB-3.
4
22. Set the center module on the Big Dipper
tank and latch the lids on each end. Place the
grease collector on the front end.
20. EECA cover should be flush with the
center module.
21. Flip the center module and secure the 5
bolts used to remove the cover – (4) in the
front and (1) on the rear side.
17. Before re-assembling the EECA, be sure
the main board and electrical plate are
aligned to their holding groove.
18. Connect the push button to the EECA push
button adapter.
19. With the skimming wheel cover open.
Place the EECA on the center module.
