5
www.usephoenix.com • [email protected]
Toll-Free 1-800-533-7533
Figure 5: electrical schematic of Phoenix D385
2.8 Storage and Transportation
The Phoenix D385 can be transported and stored in either
upright or horizontal positions.
There is a storage compartment under the top cover of
your dehumidifier. This compartment is large enough to
store reactivation collars, power cords, filter (as used), as
well as additional small items that you may require on your
job site.
3 Maintenance
3.1 Air Filter Replacement
The Phoenix D385 is equipped with two pleated fabric air
filters that must be checked regularly.
Process air stream filter:
This 16”x20”x2” filter is located in the top of your D385
underneath the top cover. The stock filter supplied carries
a MERV-11 filtration efficiency rating. This filter prevents
loading the desiccant wheel with foreign matter.
Reactivation air stream filter:
This 12”x12 x1” filter is located in the bottom of your
D385. To change the reactivation air filter, lay the D385
down in a horizontal position. The filter access slot is
located on the bottom of the machine (Fig. 4). Open
retainment clip, remove old filter, and replace with fresh
filter.
The stock filter supplied carries a MERV-7 filtration
efficiency rating. This filtration prevents plugging the heater
or loading the desiccant wheel with foreign matter.
Operating the unit with a dirty filter will reduce the
dehumidifier’s capacity and efficiency and may cause the
heater coil to cut out on thermal overload.
The filter can generally be vacuumed clean several times
before needing replacement. Replacement filters can be
ordered from the factory or purchased locally if available.
DO NOT
operate the unit without the filters or with less
effective filters as the desiccant wheel inside the unit will
become clogged and require disassembly to clean.
4 Service
CAUTION: Servicing the Phoenix D385 with its high voltage
circuitry presents a health hazard which could result in
death, serious bodily injury, and/or property damage. Only
qualified service people should service this unit.
CAUTION-ELECTRICAL SHOCK HAZARD: Electrical power
must be present to perform some tests; these tests should
be performed only by a qualified service person.
Note: Check for airflow at all inlets and outlets. Do not run
unit if no airflow is detected.
4.1 Warranty
A warranty certificate has been enclosed with this unit;
read it before any repair is initiated. If a warranty repair
is required, call the factory first at 1-800-533-7533 for
warranty claim authorization and technical assistance.
5 Wiring Diagram
Figure 4: Reactivation Filter
Retainment
clip
