8
ASSEMBLY INSTRUCTIONS FOR THERASAUNA®
1.
Place the base panel (Figure 1, page 3) on a solid
flat surface with 5 supporting blocks down. Note:
The two metal inserts will indicate the front of the
base panel.
2.
Stand back wall (Figure 2, page 3) on base with
channeled edge up, make sure to center wall along
back edge of base. Note: Base should extend out
from each end of wall.
3.
Stand left sidewall (Figure 3, page 3) with
channeled edge up on base at a 90
°
angle to back
wall. Sidewall trim forms a channel for back wall
to interlock with sidewall. Insert three furniture
bolts (Figure 12, page 5) through holes in sidewall
and screw into back wall (do not tighten bolts.)
Hex wrench (Figure 13, page 5) is provided.
4.
Stand right sidewall (Figure 4, page 3) on base.
Sidewall trim should interlock back walls. Insert
three furniture bolts through sidewall into back
wall (do not tighten).
5.
Slide left bench support panel (Figure 7, page 4)
into guides on back wall. Note: Ensure the heater
plug is facing the back wall.
6.
Slide right bench support panel (Figure 7, page 4)
into guides on back wall. Note: Ensure the heater
plug is facing the back wall.
7.
Find the 3 cords with plugs sticking out from the
hole on the lower left corner of the back wall.
Matching up the colors, connect 2 of these cords to
the 2 cords sticking out from the hole in the lower
middle of the left side wall. Connect the third cord
from the back wall directly to the plug located on
the side of the heater box in the bench support.
Again, make sure the colors match. Repeat these
steps for the 3 cords located on the lower right
corner of the back wall for the right side.