TheraSauna TS4746, Owners Manual And Assembly

Page: 9 / 15

9
8. Screw two furniture bolts into holes in threshold
inside door opening. Note: Some adjusting may
be necessary to line up holes in threshold and
threaded receivers in base using hex wrench
provided.
9. Step into sauna and facing the back wall, find two
black cords in the left side top channel of back
wall. Extend one cord down the channel of the
back wall into the channel of the right sidewall to
the right hand corner of front wall channel. Plug
in cord, making sure the colors match up, with
reciprocal end of cord from front wall. Note:
Excess cord should be woven into front or back
wall.
10. Extend second cord down the channel of the left
sidewall to the right hand corner of the front wall
channel. Plug in cord with reciprocal end of cord
from front wall. Tuck in cords.
11. Set roof (Figure 5, page 4) on sauna making sure
top trim extends down over walls all the way
around. If trim does not extend over walls all the
way around, rotate top ¼ turn.
12. Install light plug connector on light (Figure 9, page
5) into connector coming out of front wall. Screw
securely to the wall with light mounting screw
(Figure 10, page 5). See instructions included in
light box.
13. All TheraSauna’s are equipped with an LED.
perimeter light system.
a. Locate the plug coming out of the roof panel
(110Volts). Plug into wall outlet.
b. To turn on the lights, wave your hand in
front of the motion detector located on the
top of the sauna by the left side of the door.
14. Wave your hand in front of the motion detector to
turn it off.
15. Install doorknobs (Figure 8, page 5) by placing
doorknob bolt through hole in door. At the same
time place one knob onto the bolt on the outside
and the other knob onto the bolt on the inside until
both are tight against the door.
Fully Assembled TheraSauna.