TherAdapt
®
Odyssey Chair (OC-150/250) Instructions: Page 2 of 7
TherAdapt
®
Odyssey Chair (OC-150 / OC-250) Instructions
Packing List:
(2)
Phenolic chair sides
(1)
Black metal cross support
(1)
Slotted wooden seat with
(2)
black metal brackets and
(6)
½” 10/32-24 Phillips head screws, a
1” wide pelvic strap complete with
(1)
side release buckle and
(2)
double slotted rings
(1)
Slotted wooden back with
(2)
black metal brackets and
(6)
½” 10/32-24 Phillips head screws
(1)
Slotted wooden footrest with
(2)
black metal brackets and
(6)
½” 10/32-24 Phillips head screws
(4)
¼-20 x 1” Phillips Head bolts *
(4)
¼” metal washers *
(4)
¼” locknuts *
(12)
5/16-18 x 1” carriage bolts *
(12)
Large black knobs with threaded inserts *
(12)
Nylon washers *
*Included in hardware bag
Tools needed:
(1)
Phillips Head screwdriver
(1)
7/16” wrench
The Odyssey Chair must be properly assembled before use. Once fully assembled it should be
adjusted properly to the individual user to provide a customized fit.
1. Attach the metal cross support to the chair sides.
A.
Position the rear support with the “fins” facing
the front of the chair. Attach the support to one
side of the chair first, then the other.
B.
Slide a ¼” metal washer onto the ¼-20 x 1” Phillips
Head bolts. Push the bolts through the
(2)
pre-
drilled holes at the back of the chair side.
C.
Place the “fins” over the protruding bolts. Place the
¼” locknuts on the bolts and
tighten
securely
with
a Phillips Head screwdriver and 7/16” wrench.
D.
Repeat on the opposite side.
Black metal cross support
¼” Locknuts
¼-20 x 1” Phillips head
& 1/4” Metal washer
