INSTALLING YOUR
ALLCLEAR
™
FILTER:
• Run the AllClear™ Filter 24 hours a day.
• DO NOT operate the AllClear™ Filter with
a pump larger than the maximum flow
rate indicated by the filter specifications.
Operating with a pump larger than
recommended can reduce the filters
effectiveness and cause damage to the
filter or UV and will NOT be covered under
warranty.
• DO NOT operate during freezing
conditions. Disconnect, drain and store the
AllClear™ Filter in a protected area.
Watch a video of the AllClear
™
Filter installation online @
www.thepondguy.com/allclear
Determine the Location
The AllClear™ Filter is pressurized and may be installed in
any location outside of the pond on a solid surface. Avoid
locations that are prone to water puddles or areas where
the filter could fall into the pond. Filters may be left above
ground but it is recommended to partially bury the filter
in the ground, leaving only the clamp and filter canister
top exposed.
Measure
MEASURE across the top of the filter and add an inch on
each side. This will be the diameter you will need to dig
the hole.
Then tip the filter on its side and measure the length staying
2” below the filter clamp. This will be the installation depth.
Attach the Fittings
ATTACH the step down fittings to the inlet and outlet of the
AllClear™ Filter with the compression ring. Note: The o-rings
should be between the filter housing and the step down
fitting to create a watertight seal when secure.
Cut the Fittings
CUT step down fittings down to the largest connection
that will work with your plumbing. Step down fittings offer
options for use with 1”, 1-1/4” and 1-1/2” plumbing. Note:
AllClear™ Filter 1200 connects only to 1” plumbing so this
step is not necessary.
Connect the Plumbing
CONNECT the plumbing and secure with a hose clamp.
Arrows on the filter inlet and outlet indicate the direction of
water flow. Plumbing from the pump should be connected
to the inlet with the arrow pointing in towards the filter and
the discharge plumbing connected to the outlet with the
arrow pointing out away from the filter.
Plug in Pump
PLUG in your pump, then plug the UV power cord into a
standard 120-volt GFCI protected outlet. You will see a glow
in the viewing window on top of the filter while the unit
is functioning.
TrueRock™ Medium Boulder Cover
To camouflage and protect the AllClear™ Filter from the
outside elements use a TrueRock™ Medium Boulder
Cover(#510332).
Dig the Hole
DIG the hole to the measured specifications. Insert the
filter and turn so the inlet and outlet are positioned for the
easiest connection to your plumbing. Once in place, backfill
with dirt.
thepondguy.com | 866-POND-HELP (766-3435)
15425 Chets Way | Armada, MI 48005
4
5
