20
3-7 Scan mode & some global settings
Scan mode:
Good-read off-The trigger button must be pressed once to activate scanning. The light source of
scanner stops scanning when there is a successful reading or no code is decoded after the Stand-by
duration elapsed.
Momentary-The trigger button acts as a switch. Press button to activate scanning and release button
to stop scanning. The light source of scanner stops scanning when there is a successful reading or
no code is decoded after the Stand-by duration elapsed.
Good-read on-The trigger button must be pressed once to activate scanning. The light source of
scanner stops scanning when no code is successful decoded after the Stand-by duration elapsed.
Auto-detection- Good-read on
–
By setting Enable, the scanner will start operating if any nearby object
has been detected. The scanner stops scanning when no code is successful decoded after the
Stand-by duration elapsed. Once the scanner stops scanning, the present object must be removed to
enable Auto-detection.
Auto-detection- Good-read off
–
By setting Enable, the scanner will start operating if any nearby object
has been detected. The scanner will stop scanning when there is a successful reading or no code is
decoded after the Stand-by duration elapsed. Once the scanner stops scanning, the present object
must be removed to enable Auto-detection.
Barcode detection: In image auto-induction mode, barcode detection means that the scanner detects an
object similar to a barcode to trigger decoding, such as text, graphics, barcodes, and so on.
Barcode detection delay: The barcode detection delay means that the detection function is enabled
when no object is detected within the set delay.
Same barcode delay time for 1D symbols: This feature is activated only when the Scan mode is in
alternate or continuous mode. Once a 1D barcode has been scanned and output successfully, the optics
module
’
s lights must be off or moved away from the barcode beyond delay time to active a next
scanning on the same barcode.
Same barcode delay time for 2D symbols: This feature is activated only when the Scan mode is in
alternate or continuous mode. Once a 2D barcode has been scanned and output successfully, the optics
module
’
s lights must be off or moved away from the barcode beyond delay time to active a next
scanning on the same barcode.
Double confirm: If it is enabled, the scanner will require a several times of same-decoded-data to confirm
a valid reading.
Global Max./Min. code length for 1D symbol: These two lengths are defined as the valid range of
decoded 1D barcode data length. Make sure that the minimum length setting is no greater than the
maximum length setting, or otherwise the labels of the symbol will not be readable. In particular, the
same value can be set for both minimum and maximum reading length to force the fixed length barcode
decoded.
Notes:
1. Please set the max./min. length for individual barcode in later sections, if special demand is
requested.
