RES-32XR3-S for X8DTL-6/6F Installation Manual
3-28
Themis Computer
3.3.14
IP Address Source
Select the source of this machine's IP address. If Static is selected, you will need to
know and enter manually the IP address of this machine below. If DHCP is selected,
the BIOS will search for a DHCP (Dynamic Host Configuration Protocol) server in
the network it is attached to, and request the next available IP address. The options
are
DHCP
and Static.
If DHCP is selected the following items will display
:
IP Address
Enter the IP address for this machine. This should be in decimal and in dotted quad
form, (i.e., 192.168.10.253). The value of each three-digit number separated by dots
should not exceed 255 as shown in the screen below.
Subnet Mask
Subnet masks tell the network which subnet this machine belongs to. The value of
each three-digit number separated by dots should not exceed 255.
Gateway Address
This is the IP address of the gateway in the network. This is usually a router.
Mac Address
The BIOS will automatically enter the Mac address of this machine; however it may
be over-ridden. Mac addresses are 6 two-digit hexadecimal numbers (Base 16, 0 ~ 9,
A, B, C, D, E, F) separated by dots. (i.e., 00.30.48.D0.D4.60).
This enables or disables Event Messages for PEF action. Refer to Table 24.6 of the
IPMI 1.5 Specification for more information at www.intel.com. The options are
Dis-
abled
and Enabled.
BMC Watch Dog Timer Action
This feature allows the BMC (Baseboard Management Controller) Watch Dog to
reset or power down the system if the operating system hangs or crashes. The
options are
Disabled
, Reset System, Power Down, Power Cycle.
BMC Watch Dog TimeOut [Min:Sec]
This option appears if BMC Watch Dog Timer Action (above) is enabled. This is a
