RES-32XR3-S for X8DTL-6/6F Installation Manual
2-8
Themis Computer
1.
Loosen the captive knurled screw on the PCI card clamp (see
A
,
2.
Swing the PCI card clamp away from the top of the chassis, exposing the tops
of the PCI card I/O panels, and lift out the slot cover. (see
B
3.
Locate the empty slot within which a card will be installed (see
).
4.
Install the new card, making sure the I/O panel is aligned with the chassis
opening.
5.
Repeat Step 3 and Step 4 until all additional cards have been installed.
6.
Swing the PCI card clamp back to its position over the PCI card I/O panels
and tighten the captive knurled screw on the PCI card clamp.
7.
Attach any internal I/O cables to the installed PCI cards, and carefully fold
and tuck any exposed ribbon cables into the cabinet.
8.
If you have no further installations to perform, close the RES-32XR3-S for
X8DTL-6/6F chassis by refastening the top cover removed in Section 2.1.1,
“Remove Protective Top Cover,” on page 2-1.
2.1.4
Lithium Battery
2.1.4.1 Removing the Lithium Battery
Perform the following steps to remove the lithium battery:
1.
Make sure the system is powered off (see “Operation” on page 2-16).
Figure 2-6.
PCI Card Clamp
B
A
Loosen the captive knurled screw...
Captive knurled screw
PCI card clamp
PCI card I/O panels (7 total)
. and swing the PCI card clamp upward.
