Themis RES-22XR3, Installation Manual

Page: 59 / 162

2-9
Themis Computer
2—Installation and Operation
Installation Procedures
2.1.4.2 Installing a Lithium Battery
Perform the following steps to insert a new lithium battery (CR2032):
1. Tilt the replacement battery into the empty socket so that it is angled under the
battery latch (see
B , Figure 2-7 ).
2. Carefully press down on the battery until it clicks firmly into place.
2.1.5 SAS/SATA II Storage Drive
Perform the following steps to remove and install a storage drive, which may be
either SAS (X8DTH-6F motherboard only) or SATA. The front doors of the RES-
22XR3 must be unlocked and opened to access the storage drives (see
Figure 2-8 ).
2.1.5.1 Opening the RES-22XR3 Front Doors
The knurled captive screw on the front of the RES-22XR3 allows the doors to lock
without a key. To unlock the doors, turn the screw counterclockwise and pull both
doors away from the chassis.
The accessory kit shipped with your RES-22XR3 contains two barrel lock keys. This
Figure 2-8.
Opening the RES-22XR3 Front Bezel Doors
Knurled
Screw
Note: The type and location of storage drives must be specified at the time of the
order to provide the internal cabling.