Begin Session Press Start/Pause button to confirm your choices and start session.
End Session TheBrainDriver will automatically shut down after the 20 or 30 minutes session time has lapsed. To
end a session at any time, simply power down the device by pressing the Start/Stop button for 3 seconds.
Pause/Resume At any time you can pause your session by pressing the “Start/Pause” button.
To resume your session, press the “Start/Pause” button again. Press the Start/Pause button again.
Preparing the Electrodes and Sponges. Detailed Steps
TheBrainDriver comes with two pairs of sponges. Use one pair at a time and keep the second pair for future use.
Prepare your saline solution: Add 1/4 to 1/2 tsp of table salt to an 8 oz. glass of fresh water. Preferably lukewarm
temperature. Stir gently until the salt granules have dissolved into the water.
Wire set. Insert the red and black metal leads securely into the hole of each of the grey silicone electrodes.
Sponges. Insert one sponge securely into each of the grey silicon electrodes. (1 sponge per electrode)
With sponges inserted, submerge the electrodes into the saline (salt water) solution until the sponges are soaked.
Lightly squeeze out any excess water so that the sponges are not dripping.
Connect the wire set into the top of TheBrainDriver™ tDCS device.
Place the electrodes following the montage you have chosen. (Make sure there is as little hair as possible between
electrodes and skin.)
Use the headband to hold the electrodes in place.
Press the ON/OFF button and hold for approximately 3 seconds until screen turns on.
Select Session Time: Press “T” to toggle the session timer between 20 or 30 minutes.
Select Output Level: Press “U” to increase output from 0.5mA up to 2.0mA. The default output is set to the lowest
setting, 0.5mA. This is where we recommend beginning each session. Press D= Adjust the power down. *Tip : You
can also continue pressing the “U” or “D” button to scroll through all the outputs; 0.5mA, 1.0mA, 1.5mA, 2.0mA
Begin Session Press Start/Pause button to confirm your choices and start session.
End Session. TheBrainDriver™ will automatically shut down after the 20 or 30 minutes session time has lapsed. To
end a session at any time, simply power down the device by pressing the Start/Stop button for 3 seconds.
Pause/Resume: You can pause your session at any time by pressing the “Start/Pause” button. To resume your
session, press the “Start/Pause” button again.
When the session has ended, we recommended that you rinse the electrode sponges with fresh water to remove
the saline (salt). Remove the electrodes and place them on their support in the original packaging.
Notes:
-For safety, the device will automatically go into pause mode within 2 seconds if either or both electrodes detach or
lose conductivity. If this happens frequently, make sure that you have parted any hair that may be interfering with
