Note:
The time and date can also be changed in the “Service” menu
(see chap. 5.4). There you can also set the changeover from winter to
summer time.
4.5
Selecting the Temperature Profile
4.5.1 Program P1 (freely selectable)
Comfort temperature Mon-Fr from 5.30 - 9.00 and
21.00 - 23.00 hrs; Sat and Sun 7.00 - 11.00 and
21.00 - 23.00 hrs; in between lower temperature
4.5.2 Program P2 (freely selectable)
Comfort temperature Mon-Fr from 5.30 - 8.00 and 16.00 - 22.00 hrs;
Sat and Sun 6.00 - 8.00 and 16.00 - 23.00 hrs.
4.5.3 Program P3 (freely selectable)
The program P3 is an individually programmable temperature profile.
Program P3 is not programmed when delivered. For programming
see chap. 5.
4.5.4 Permanent comfort (using Comfort + Reduced 1)
The room temperature is permanently regulated to the programmed
comfort temperature. There is no reduction.
4.5.5 Permanent reduction (using Comfort + Reduced 1)
The room temperature is permanently regulated to the programmed
lower temperature.
4.5.6 Antifreezing
The room thermostat only comes on when the room temperature
falls below the programmed antifreeze temperature.
4.6
Checking Current Room Temperature and
Settings - lnfo Button
With the
lnfo
button you can display the current room temperature
as well as all important settings of the program set at the rotary
switch.
1. Press the
Info
button. The current room temperature is shown in
the display for approx. 3 seconds. In order to continue with the
check, press the
lnfo
button again.
2. This way you can check the following information one after the
other:
- Temperature
- Currently active target temperature
- Date and time
- Set display type, (i.e. which information is shown in the
display, also see chap. 5.4.2)
- Reset operating hours
20
ENGLISH
P2
P3
P1
MENU
1. The display shows the time setting.
2. Set the current time with the buttons
and
:
Set the hour and confirm with the
OK
button.
Set the minutes and confirm with the
OK
Year
2002
Month
04
OK
Day
09.04
OK
3. The display changes automatically to
the date setting.
Set the year, month and date one
after the other. Confirm each setting
with the
OK
button. The display
changes automatically.
4. The display automatically changes to the set automatic mode,
e.g. display of the target temperature.
