P.9
HM3x22mm Screw
HM3x22mm
PA3x22mm Screw
PA3x22mm
1
2
d3xD7mm Washer
Washer
d3xD7mm
d3xD7mm
Step 1. Insert the aluminum wing tube with the pre-drilled hole end into the right wing.
Align the lines
marked at the wing root and wing tube and apply the HM3 x 22mm machine screw through the pre-
drilled hole on top of the wing.
( please confirm the alignment of the hole by putting a 2.5mm diameter
rod through the pre-drilled wing hole before applying the screw )
The hole on the wing tube is pre-
threaded, do not over tighten the HM3 screw, the set up is for future removal of the wing.
Step 2. Install the right wing to the fuselage
by inserting the wing tube (now attached to
the right wing) through the fuselage, then
install the left wing.
S t e p 3 . M a k e s u r e t h e w i n g s a r e r e s t i n g a g a i n s t t h e f u s e l a g e t i g h t l y.
L o c a t e t h e p r e - d r i l l e d
2 . 5 m m h o l e a t t o p o f l e f t w i n g , a n d d r i l l a l o n g w i t h 2 . 5 m m d r i l l b i t u n t i l i f p a s s e s t h r o u g h t h e
w i n g t u b e .
A p p l y t h e PA 3 X 2 2 m m s e l f - t a p p i n g s c r e w .
Note : It is recommended that the wing tube stays with the left wing.
Removal of the wings could be
achieved by removing the right wing machine screw, the right wing then the left with wing tube.
If
removal of wing tube from left wing is also required, it is recommended that instead of applying self-
tapping screw in step 3, you pre-tap with M3 thread cutter and apply M3 machine screw.
1
3
Top View
Left
Right
Wing Tube
1
2
Lead to Aileron Servo
Wing Lock Pin 1.2 x 20mm
2.5mm
A143PO22951003
