P.9
Control Throws
14
C.G.
15
Adjust the control throws as shown in the
diagram. These throws are good for general
flying. You can adjust according to your
personal preference.
The ideal C.G. position is
75mm ( 2.96 in )
behind the leading edge
measured at where the wing meets the fuselage. In order to obtain
the C.G. specified, add weight to the fuselage or move the battery
position. Check the C.G. before flying.
Rudder
25mm
25mm
Elevator
15mm
15mm
12mm
12mm
Aileron
Important Safety Precautions
E253XMPO21770909
Warning!
75mm
C.G.
2.96 in
# First time flyer should never fly by himself / herself. Assistance from experienced flyer is absolutely
necessary.
# Pre-flight adjustment must be done before flying, it is very dangerous to fly a badly pre-adjusted aircraft.
# is specially designed to be powered by
KM0283010 Outrunner Motor
.
# Make sure the air field is spacious, never fly the plane too close to people and never get too close to a
running propeller. Extreme caution should be exercised when working with electric powered models.
Make sure the propeller is cleared of all objects, especially your hands before connecting the battery to
the model. Make sure you understand the operation of the ESC (Electronic Speed Control) by studying
the ESC manual. Once you plug in the battery for electric powered model, always treat the propeller as
a rotating one, as accidental movement of the throttle stick will spin the propeller and could cause injuries.
# If you find wrinkles on the covering as a result of weather changes, you can use hot iron to remove the
wrinkles. Please begin with lower temperature setting and gradually raise the temperature until the
wrinkles are gone. Too hot an iron may damage the covering. Don't use hot iron near the seams or
edges, hot iron will melt the glue and shrink the covering at the same time, causing the seams to pull away.
# Check and re-tighten up all factory assembled screws, use thread locker if necessary.
Katana EP
