P.12
19
Control Throws
20
C
.
G
.
The ideal C.G. position is 177.8mm (7.0in.) behind the leading edge measured at where the wing meets the
fuselage. In order to obtain the C.G. specified, add weight to the fuselage or move the battery position.
Check the C.G. before flying.
If you are converting this model to electric, please move the C.G. forward 5% of current C.G. distance from
leading edge to compensate for weight of fuel.
177.8 mm
http://www.theworldmodels.com/para/instruction/instructionManuals.php
C.G.
7.0 in.
Important Safety Precautions
Warning!
# First time flyer should never fly by himself / herself. Assistance from experienced flyer is absolutely
necessary.
# Pre-flight adjustment must be done before flying, it is very dangerous to fly a badly pre-adjusted
aircraft.
#
is specially designed to be powered by
50c.c. gasoline
engine, using a more
powerful engine does not mean better performance. In fact, over powered engine may cause
structural damage and injuries.
# Make sure the air field is spacious, never fly the plane too close to people and never get too close
to a running propeller.
# If you find wrinkles on the covering as a result of weather changes, you can use hot iron to remove
the wrinkles. Please begin with lower temperature setting and gradually raise the temperature until
the wrinkles are gone. Too hot an iron may damage the covering.
Don't use hot iron near the seams
or edges, hot iron will melt the glue and shrink the covering at the same time, causing the seams to pull
away.
# Check and re-tighten up all factory assembled screws, use thread locker if necessary.
Adjust the control throws as shown in the diagram.
These throws are good for general flying. You can
adjust according to your personal preference.
Aileron
35mm
Elevator
35mm
Rudder
65mm
65mm
35mm
35mm
A331PO27801211
