P.4
T he Wor ld M ode ls
T he Wor ld M ode ls
2.1
2.2
2.3
3.1
1.20
Basic fabrication of fuselage is complete. Check any loo-
se joints and distortion of the frame work. Prepare to ap-
ply glue in the next step.
Expose 5~10mm length section for the pushrod sleeves
outside the plywood partition and apply CA to fix it in po-
sition. Make sure glue does not get inside sleeve.
Apply CA glue to all surfaces in contact. Apply from both
sides in and out and let glue seep into joints. Use exten-
sion tube through side panel holes to get access to inside
of fuselage. Avoid area with tapes at this stage, when
glue is cured at other areas, remove tape and apply glue
to area under the tapes.
If epoxy was not used in Step 1.19, apply adequate CA
to the F1 joints.
Remove tapes after glue is cured, flip over fuselage and
prepare to work on bottom of fuselage. Rest fuselage on
foam blocks or other material to clear the partition plywood
from table, which could be damaged under stress.