Important Safety Precautions
23
Control Throws
Adjust the control throws as shown in
the diagram. These throws are good for
general flying. You can adjust according
to your personal preference.
Aileron
40mm
Elevator
50mm
Rudder
65mm
24
C
.
G
.
The ideal C.G. position is
150mm (5.9in.)
behind the leading edge measured at where
the wing meets the fuselage. In order to obtain the C.G.specified,add weight to the
fuselage or move the battery position. Check the C.G. before flying.
65mm
50mm
40mm
Warning!
150 mm
5.9 in.
C.G.
# First time flyer should never fly by himself / herself. Assistance from experienced flyer is absolutely
necessary.
# Pre-flight adjustment must be done before flying, it is very dangerous to fly a badly pre-adjusted
aircraft.
#
1/3 PAULISTINHA P-56
is specially designed to be powered by
80c.c.
engine, using a more powerful
engine does not mean better performance. In fact, over powered engine may cause structural
damage and injuries.
# Make sure the air field is spacious, never fly the plane too close to people and never get too close
to a running propeller.
# If you find wrinkles on the covering as a result of weather changes, you can use hot iron to remove
the wrinkles. Please begin with lower temperature setting and gradually raise the temperature until
the wrinkles are gone. Too hot an iron may damage the covering.
Don't use hot iron near the seams
or edges, hot iron will melt the glue and shrink the covering at the same time, causing the seams to pull
away.
# Check and re-tighten up all factory assembled screws, use thread locker if necessary.
P.12
A324PO24581008
