11
FOR VIDEO INSTALL INSTRUCTIONS GO TO TheStandingDesk.com/install
STANDING
THE
DESK
THE KLOUD
FLEXI LIFT TABLE
ASSEMBLY INSTRUCTIONS
TOOLS/
ACCESSORIES
Using the ratchet wrench or manual driver with the l0mm hex bit, adjust
the pneumatic force by turning the hex adjustment found on the side, next
to the gauge.
•
See the graph below right for a 48” table base. At the 0/0 gauge reading, weight
is set for just under 50 lbs. That moves up slowly to about 60 lbs at the 4/0 gauge
reading and then increases more rapidly, to over l00 lbs at the 8/0 gauge reading.
Do not adjust past the 8/0 setting due to risk of damage.
•
If you know the approximate weight of the table top (work surface plus contents),
you can go to the gauge reading for that weight.
•
The goal in making this adjustment is to equalize the force needed to raise the
table with the force needed to lower it. This is important when testing operation.
15
Adjust cable tension if necessary.
•
If the table does not lock into place when the lever is released, tighten the
cable adjustment nut one-half turn and recheck.
•
If the table stays locked in one place or moves slowly, loosen the cable adjust-
ment nut one-half turn and recheck.
If needed adjust bowden cable. The lever of the hand release
should have a little play in a non activated position.
TOOLS/
ACCESSORIES
16
8mm
10mm
Hex Bit
Ratchet
Wrench
