1
Remove the battery compartment cover on the back of the microphone by
using a Philips-head screw driver
.
2
Insert three (3) “AAA” size alkaline
batteries (not included) as indicated on the
below diagram.
3
Replace the cover tightly before operating.
4
Connect the Hype Mic into the microphone jack of your Singing Machine unit.
Note:
- Replace all batteries at the same time.
- Do not mix old batteries with new batteries.
- Do not drop or tap the microphone as damage to the microphone or speaker may
occur.
- Do not twirl the microphone cord as it will cause damage to the encased wiring.
Install Batteries
Operation
1
Connect the Hype Mic into the mic jack
of your Singing Machine unit. (visit:
www.singingmachine.com for more
information).
2
Press and hold the
POWER
button
to
turn the unit on; the voice changer ring
indicator will light up.
SING-ALONG WITH BUILT-IN SONGS
3
There are 3 built-in songs. Press
1
,
2
or
3
buttons to play them one by one.
4
Press
STOP
button to stop.
PLAYING BUILT-IN EFFECTS
5
Press , or buttons to
play three different built-in sound
effects.
SING-ALONG WITH BUILT-IN VOICE
CHANGERS
6
There are 6 built-in voice changers in
this Hype Mic. When rotating towards
center (as indicated on the right
diagram
U
) indicator will light up. The
voice will change when the singer starts
to sing through the microphone.
Purple light - ECHO
Pink light - Female voice
Orange light - Male voice
Lime light - Chipmunk
Cyan light - Robot
Blue light - Radio
Select NONE to sing without any voice
effect and indicator will light up red.
7
You can adjust the microphone volume
on your Singing Machine unit. (Also
refer to the Singing Machine’s User
Guide.)
BATTERY PRECAUTIONS
The precautions below should be followed when using batteries in this device:
1. Warning – Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type.
2. Use only the size and type of batteries specified.
3. Be sure to follow the correct polarity when installing the batteries as indicated
in the battery compartment. A reversed battery may cause damage to the
device.
4. Do not mix different types of batteries together (e.g. Alkaline, Rechargeable
and Carbon-zinc) or old batteries with fresh ones.
5. If the device is not to be used for a long period of time, remove the batteries
to prevent damage or injury from possible battery leakage.
6. Do not try to recharge a battery not intended to be recharged; it can overheat
and rupture. (Follow the battery manufacturer’s directions.)
7. Remove the batteries promptly once its charge is low.
8. Clean the battery contact and also those of the device prior to installing the
battery.
Troubleshooting Guide
Should this unit exhibit a problem, check the following before seeking service:
No Power
• Replace with new batteries.
No sound from the microphone
• Make sure the Hype Mic is firmly connected to your Singing Machine unit’s mic
jack.
• Press and hold the
POWER
button
to turn the Hype Mic on.
• Your Singing Machine unit’s
MASTER VOLUME
or
MIC VOLUME
is set to
minimum; raise volume.
ENERGY SAVING (AUTO POWER
SYSTEM-APS)
The unit will automatically enter the Standby mode after 15 minutes in the
following situations:
1. No button being pressed for 15 minutes.
2. Not singing to the microphone for 15 minutes.
The unit can be turned on by pressing the POWER button once. APS is for energy
saving purposes.
v
w
x
y
U
