10/2021 V 1.1
VIEW 31DW
Glass Inline Panel
Glass Return Panel
Glass to Glass Adhesive Tape
07/16
Before Installing the Glass to Glass
Adhesive Tape, ensure that the Tape is
orientated and posi�oned correctly on
the Glass Inline Panel as shown below.
Posi�on the Glass to Glass Adhesive
tape on the correct edge of the Inline
Panel. Using a cloth or towel, apply the
Tape to the Panel.
Peel back the protec�ve adhesive strip
while firmly applying the Tape.
Cut excess Tape using a blade.
Using purpose built “Glass Li�ers”,
carefully place the Inline Panel on to
the Underframe Gasket and push
against the Return Panel.
Note the orienta�on and posi�on of
the Panel, this can be determined by
any holes or a�ached labels.
Remove and replace the Panel adding
or subtrac�ng spacers as necessary to
level the Panel (to a maximum height
of 5mm inside the Underframe).
Check the Panel is level using a Spirit
Level. If the difference between the
two Panels is greater than 5mm, it may
be necessary to lower the Return
Panel.
25
26
27
28
