The Handy S.A.M. 1000, Manual

Page: 2 / 4

S.A.M. 1000 AIR LIFT
NOTE: READ ENTIRE MANUAL TO COMPLY WITH ALL SAFETY AND SERVICE PRECAUTIONS.
DEATH, PERSONAL INJURY AND/OR PROPERTY DAMAGE MAY OCCUR UNLESS INSTRUCTIONS
ARE FOLLOWED CAREFULLY.
INSTRUCTIONS
UNPACKING AND SET-UP
1. Open carton, then remove ramp and shipping boards.
2. CAREFULLY TURN TABLE UPRIGHT INTO OPERATING POSITION BEFORE REMOVING
SHIPPING CABLE RESTRAINT FROM SCISSOR MECHANISM.
3. Connect foot-operated air valve to 100 psi maximum air supply. The lift may be damaged
and/or personal injury may result if the pressure exceeds the maximum 100 psi rating.
4. Stand clear of lift table, and depress the UP side of foot valve to raise table.
5. To lower table, lift detent bar from safety latch and lower to next position or to floor.
6. Place drop-out cover over dropout opening.
7. Insert ramp mounting pins into holes at either end of table to mount ramp.
NOTE: If cycle vise is being installed, ramp must be mounted opposite the cycle vise.
OPERATION
1. Loads must be centered on table at all times. Table is rated for a maximum load of 1000 lbs.
2. Loads must be firmly positioned and secured on table at all times.
3. All moving parts have been lubricated at the factory and should be re-lubricated every (6) months
to prevent galling. Grease zerks are located at each end of frame pivot shaft and at top ends of
inside frame assembly.
4. Lightly oil cylinder rod when it becomes dry.
5. Squirt some oil through bleed hole in plate end of cylinder to lubricate piston and its seal every
(6) months.
6. Pivot shaft set screws should be checked frequently to be sure they are tight. These are
located at the top end of the inside frame assembly.
OTHER OPTIONS AVAILABLE
Separate installation instructions included with each option.
é
PART # DESCRIPTION
14476
CV-17 CYCLE VISE – Vise with removable wheel stop built into vise
10728
12” SIDE EXTENSIONS (2) – Expands width of lift from 24” to 48” includes stabilizer
bar
16011 13” FRONT EXTENSION – Extends lift top to 93” for longer wheel base motorcycles
10736 13” REAR EXTENSION – Extends lift top to 93” for longer wheel base motorcycles
15566 RAMP END EXTENSIONS – Attaches to end of lift ramp for a more gradual incline to
prevent bigger bikes from dragging bottom.
16355 CE FOOT PEDAL – Covered foot pedal
10732 LIFT DOLLY – Helps move lift while in down position
16010 TOOL TRAY – Keeps tools organized and Handy