manualshive.com logo in svg

The Handy 21660, Instructions

Share
Download
The Handy 21660 Instructions Download Page 2

HANDY, DIVISION OF JANCO INDUSTRIES INC. 

600 West 2

nd

 Ave. Sully, IA 50251 – Ph: 855-752-5446 – www.handyindustries.com 

DECK HAND 

 

ASSEMBLY INSTRUCTIONS:

 

1.Remove contents from carton, and make sure all pieces are accounted for. 
 
2. Take mount 21625 and place it on the lift top at the front of the lift, then take mount 21630 (21665 if 
mounting to Gruntavore Lift) and place it under the lift top. Use 6-

3/8” bolts provided to bolt through the mounts 

securing them to the lift top. Please see diagram below for bolting configuration. 
 

NOTE: Customer may need to drill additional holes in their lift top depending on the age of the 
lift. If so use mount 21625 as a template to mark holes. 6-

3/8” bolts are required to mount the 

Deck Hand to a lift top.

 

 
 
 
 
 

 

 
 
 

Summary of Contents for 21660

Page 1: ...and which upon our examination any parts which are defective in manufacture or workmanship will be replaced or put in good operating condition This warranty does not apply to damage resulting from accident improper installation repair operation or maintenance negligence or neglect The cost of such replacement or repair shall be exclusive remedy for any breach of any warranty and Handy Industries s...

Page 2: ...op at the front of the lift then take mount 21630 21665 if mounting to Gruntavore Lift and place it under the lift top Use 6 3 8 bolts provided to bolt through the mounts securing them to the lift top Please see diagram below for bolting configuration NOTE Customer may need to drill additional holes in their lift top depending on the age of the lift If so use mount 21625 as a template to mark hole...

Page 3: ...First put shim on stud followed by handle Then install washer and retaining nut provided DO NOT OVERTIGHTEN NUT Tighten nut by hand using an end wrench DO NOT use impact wrench Twisting off the stud voids winch warranty Raise lift arm slightly by cranking winch clockwise this will allow room to place support tube 21633 into 21610 Use 2 provided 1 2 bolts lock washers and nuts to secure the support...

Page 4: ... procedure will allow the rear tires to roll freely 4 Be sure the safety lever is engaged on the lift before operating The safety lock should be in the ON position for lock to engage in detent teeth 5 Rotate the handle clockwise to raise lift to desired height 6 To lower the lift Raise lift enough to release pressure on safety lock Move lever to OFF position Turn the crank handle counter clock wis...

Reviews:

No comments

Brands by name

Popular brands

Load more brands