IMPORTANT
If your cabinet(s) have been built to accomodate your Galley Workstation, proceed to Step One.
If you are joining two or more cabinets together to house the Galley Workstation,
you will need to trim the bulkheads to create an 11" clearance for the Basin.
1. Please note: Unlike typical undermount kitchen sink installations, The Galley Workstation is installed in the cabinet prior to the
counter being templated.
A wood support frame will need to be constructed and mounted inside the base cabinet(s) and
recessed down 1/16" from the top of the cabinet(s).
2. Leave the installation instructions tray affixed to The Galley Basin until the countertop has been templated, and leave the basin
braces affixed to the Basin’s tiers until the countertop has been installed and silicone has cured for a minimum of one hour.
3. The Workstation and Tap require a
minimum
of 22 1/2” inside the cabinet. For 24” deep inset cabinets installed against a wall,
the cabinet must be pulled 1” away from the wall.
4. For countertops with a laminated or built-up decorative front edge, construct the wood support frame to finish 1/16” below the
underside of the countertop cutout area.
Inspect The Galley Basin for any damage prior to installation. For any questions or concerns please contact us immediately
at 800.375.4255 or [email protected].
Please refer to all local plumbing and building codes prior to installation.
Before You Begin
Tools
DRILL
2” PAINTERS TAPE
CIRCULAR SAW
LEVEL
TAPE MEASURE
WOOD SCREWS
CLAMPS
(OPTIONAL)
100% CLEAR SILICONE
SPRAY BOTTLE
(4) 1" X 6"
HARDWOOD BOARDS
(OR ANY SIZE A CARPENTER DEEMS
TO BE MOST EFFECTIVE)
5
CLOTH
