background image

GUILDER VANITY COLLECTION

24”

30”

36”

TOOLS AND EQUIPMENT

IMPORTANT - PLEASE READ BEFORE INSTALLATION

Please read these instructions carefully before starting the  

installation process and keep in a safe place for future  

reference. 

Important

: To reduce the risk of product damage, DO NOT 

modify the vanity. Doing so will compromise the sturctural 

stability and void the warranty. This manual contains proper 

information on how to install the Guilder Collection. 

Note:

 This series comes in several sizes however the 

installation procedures remain the same. Observe all local 

building codes. Two people should install this product. 

This vanity series needs specifi c site preparation. Do not install 

your vanity until all support framing and plumbing rough-ins 

have been completed and wall surface is fi nished. 

Secure the vanity to stud framing. When possible, provide 2x6 

timber behind the fi nished wall for additional support. To ease 

the installation process, remove the drawer from the vanity 

before installation. Refer to the section in this guide for drawer 

removal. 

This product should only be installed by a qualifi ed profes-

sional pulmber or contractor. If the installation is completed 

by a non-qualifi ed professional person, any product garantee 

maybe considered invalid. Enusre the room is well heated 

and ventilated. 

Warning:

 always check for any hidden pipes or electrical 

cables before drilling holes in the fl oor or walls.  Do not over 

tighten tap or waste fi ttings. Doing so may result in damag-

ing the countersink. 

The vanity can only be installed using the fi tting brack-

ets supplied.

 Before installing a wooden bathroom product 

into a new property extension or recently plastered room we 

strongly advise the building/room be completely dry, well 

ventilated, and adequately heated prior to installation. 

Save these instructions for future use and reference. An 

improper installation voids the warranty. Installed vanities 

cannot be returned. If you experience any problems with your 

vanity, contact your dealer or The Furniture Guild directly. 

Summary of Contents for GUILDER VANITY 24

Page 1: ... ease the installation process remove the drawer from the vanity before installation Refer to the section in this guide for drawer removal This product should only be installed by a qualified profes sional pulmber or contractor If the installation is completed by a non qualified professional person any product garantee maybe considered invalid Enusre the room is well heated and ventilated Warning ...

Page 2: ...tud framing or 2x6 bracing behind the finished wall When installing 2x6 bracing front notch the studs to ensure the bracing sits flush against the studs The bracing should span the length of the vanity Consider for routing supply and drain piping for your desired sink IMPORTANT To ensure proper support and alignment the finished wall must be straight and plumb Complete and finish the wall decorati...

Page 3: ...the countersink Let silicone dry for 24 hours A B Re Fit Drawers 1 Pull drawer runners fully out 2 Set the drawer down onto the runners 3 Push the drawer fully in Test to make sure the drawers operate correctly and there are no obstructions behind the drawer D a Check to see if the vanity is level If leveling is required use a screwdiver to adjust the hanging positions as follows b To lift or lowe...

Page 4: ...use any petroleum based products when cleaning like paint thinner or other such solvents They will damage the vanity To clean the Fireclay countersink use a soft dampened sponge or cloth and mild soapy water Never use strong or abrasive cleaners Wipe surfaces clean immediately after applying cleaner Never allow a cleaner to sit or soak CLEANING GUIDE For height adjustments squeeze and pull the fro...

Reviews: