Page 6
Cleaning and Storage Continued:
1. Turn off the Pump by pressing the Power Button. The Light on the top of the Pump should turn off.
2. Operate the Pressure Release Valve on the side of the Tank by gently pulling it outward until the air
inside the Tank stops flowing out.
3.
Rem
ove the Pump from the Tank by turning it counter-clockwise. Avoid placing the Pump down
where it may become contaminated with dirt, or debris that could later enter the Tank.
4. Use clean water to thoroughly rinse and empty the Tank until all residues are removed.
5. Use a wet cloth to wipe the bottom of the Pump until all residues are removed. Do not rinse the
Pump with a hose or submerge in water, as water will enter the Housing, damaging the
electrical components, rendering the Pump non-functional, and voiding the warranty.
6. Add approximately 1 quart [1 liter] of clean water to the Tank.
7. Attach the Pump to the Tank and tighten firmly.
8. Press the Power Button so the Pump will pressurize the Tank.
9. With clean water in the clean Tank, dispense water through the Hose and Quick Connect for at least
30 seconds to rinse them out. Failure to rinse out the Hose and Quick Connect may allow residue
build-up that can clog or damage the components.
10. Press the Power Button to turn off the Pump.
11. Operate the Pressure Release Valve on the side of the Tank to release pressure.
12. Remove the Pump. Avoid placing the Pump down where it may become contaminated with dirt or
debris that could later enter the Tank.
13. Open the Quick Connect (depress Lever) to drain any remaining water from the Hose.
(See Figure L)
14. Empty out any remaining water from the Tank.
15. Allow the Device to dry. This is best done by hanging the Tank upside down to let it drain.
16. Once the Device is dried turn the Device upright and loosely assemble the Pump to the Tank to
prevent debris from entering the Tank.
17. Store the Device, Pump, and Charger indoors in a warm, dry location out of direct sunlight and
away from any sources of moisture or intense heat. Do not store Device where freezing tempera-
tures (below 32°F/0°C) will occur. Allowing water to freeze inside the Device may damage
the Pump, Seals, Quick Connect, or other components, and void the Device warranty.
18. To ensure optimal Battery life the Battery should be charged at least once every 3 months when not
in use. See
Charging the Pump Internal Battery.
DEVICE MAINTENANCE CONTINUED
Figure L