C. Assemble Changing Table
1. Place changing table fabric upside down.
2. Slide loops (labeled A) on each side
over 1 fabric support tube.
3. Insert 2nd fabric support tube into
open end of the fabric support tube that
you just attached to the changing table.
4. Connect both fabric support tubes
together.
D. Attach Changing Table to Stand
1. Turn changing table assembly right side up and
place on top of stand. Fold over the ruffled skirt so
that screw holes are visible.
2. Position loops making sure they are between screw
holes.
3. Insert plastic nut into screw holes by pushing up
through bottom.
4. Holding plastic nut in place, use 1 long screw into
top hole and tighten with Philips screwdriver. Do
not tighten all the way until all 4 screws and
plastic nuts are in place. Once they are all in place,
tighten all screws.
5. Squeeze rod supports into place as shown. Make
sure that they are firmly inserted into holes in
stand.
6. Snap brackets over fabric supports. Align holes
and push short screw into place. Secure nut
using pliers.
7. Wrap 5 self-fasteners around fabric support
tubes and foam pads as shown, doing center
one last. Repeat for other side.
8. Pull fabric over and straighten ruffle as desired.
PRODUCT ASSEMBLY (con’t)
6
A
Foam Pad-
Do not remove
1 2
3
4
5
3073manualfinal.qxd 2/1/05 10:28 AM Page 7
