Assembly Instructions for the LED At A Glance Remote Display
The Cary Company
1195 W. Fullerton Ave.
Addison, IL 60101
thecarycompany.com
Contact us for help:
Ph: 630-629-6600
1. Unscrew mechanical gauge vial retainer and lift vial and retainer off.
2. Place magnet holder on indicator, and replace vial and retainer over magnet holder and screw
retainer back down.
3.
Skip step one and two if your gauge and LED were ordered together. In this case, your indicator
and magnet
are already installed.
4. The clamp, clamp screws, and transmitter should already be assembled. Slide the transmitter and
clamp down over the vial.
5. Looking at the top view (the picture on bottom right), line the transmitter up with the magnet as
shown in the picture and tighten the two lock down screws.
6. To install battery, unscrew the battery box and pull the tab for access to battery compartment.
7. Remember that this is the location of the alarm settings (see user guide).
8. View the current fuel level using the mechanical float gauge.
9. Press the “Push” button once to check the level on the remote display.
10.Slide the transmitter up or down until the mechanical gauge reading matches the electronic gauge
reading.
11.Tighten the lock down screws to lock the transmitter into place.
12.Mount the display in a convenient location.
Indicator
Magnet Holder
Retainer
Transmitter
Vial
Clamp
Lock Down Screws
Clamp Screws
Top View
Before installing battery, see user guide for alarm settings. Default settings have the alarms turned off.
Retainer
Clamp
Vial
Magnet
Transmitter
