6
5
GLIDERPOLE
®
SQUARE POLE - H27mm (1
1
/
16
”)
FINIALS
Attach the finials by pushing them into position
and tightening the set screws on the finial.
FITTING GLIDERPOLE TO THE BRACKETS
When fitting the track ensure the
higher edge of the profile is at
the front.
Offer the gliderpole up to the bracket, and tighten
the button head screw into the fixing insert, ensuring
that the pole is fully secured. Making sure that the
overhangs at each end are equal.
If the gliderpole is made of two connected lengths,
the mid bracket should be fitted on the join.
In this instance remove the fixing insert & screw
the button head screw directly into the joiner.
Fixing inserts are pre-installed into the poles.
Spare fixing inserts are supplied with the brackets.
JOINING THE GLIDERPOLE
Gliderpoles are supplied pre-cut to your specified lengths, in
some cases the Gliderpole may be made in two or more parts,
joined by a connector.
Push the joiner into the pole ends and push the gliderpoles
together. Tighten the set screws in the top channel of the pro-
file.
!⃝●
PLEASE NOTE, All joins must be supported by a bracket.
If there is a gap between joins gliders/rollers may
not run efficiently.
ADDING AND REMOVING
GLIDERS/ROLLERS
Gliderpoles are supplied with
gliders/rollers pre-installed, in some
instances it may be necessary to
add or remove gliders, to do this
follow the steps on page 9.
POSITIONING & FIXING
SINGLE & DOUBLE BRACKETS
FOR ALTERNATIVE BRACKETS TYPES SEE PAGE 7-8
Brackets should be positioned approximately 100mm (4”) from the ends of the pole.
❶
Mark the position of the brackets. For longer poles one or more mid bracket are required,
and should be equally spaced along the system.
PLEASE NOTE, Where systems are made in multiple sections.
Joins must be supported by a mid bracket, which must be fitted directly over the join.
To align the brackets, the top of the mid brackets should be fitted in line with the top of the side brackets.
❷
Drill holes & use a suitable wall fixing when attaching the plate to the wall.
❸
Screw each bracket into position.
Fit the cover plate, the cover is held in place by magnets.
BRACKET ALIGNMENT
BRACKET ALIGNMENT
Fixing Insert
Button Head Screw
CLICK
