STEP 1
Locate the wagon tray (O) and rear axel (F).
Using bolts, washers and nuts (C) attach rear
axel to the wagon tray. Washers and nuts should
be on the under side of the wagon. Tighten
nuts and bolts using #2 Phillips screwdriver and
10mm wrench.
STEP 2
Slide rear axel supports (G) onto the axels and
attach to wagon tray (O) using bolts, washers
and nuts (C). Tighten nuts and bolts with #2
Phillips screwdriver and 10mm wrench.
STEP 3
Install front axel (I) onto front axel support (J)
and secure them with a flat washer (D) and a
cotter pin (E) making sure to bend both ends
of each pin so that you form a butterfly shape.
STEP 4
Connect entire front axel assembly to the wag-
on tray (O) using bolts, washers and nuts (C).
Tighten bolts with #2 Phillips screwdriver and
10mm wrench.
