DOCUMENT No.:
REVISION: 1.2
DATE: 2014/11/10
DC-MAM-001-X-C-2
Page 203
F
F
A
B
C
D
E
PROCEDURE (REMOVAL)
Retain any bolts, clamps, spacers, screws and washers (with the exception of lock-washers) for reassembly.
1.
Remove the centre console side inspection panel.
2.
Remove the split pin and discard.
3.
Undo the castle nut, support the throttle lever and pull out the bolt, and remove the friction washers.
PROCEDURE (INSTALLATION)
1.
Reverse the above procedure (removal), paying close attention to the following:
Do not re-use split pin. Fit new.
Inspect castle nut and bolt for damage. Replace if necessary.
2.
Adjust the throttle lever friction (refer to paragraph 5.2.14.1).
Figure 46: Throttle lever friction disc installation
.
A
AN3-7 bolt
B
AN3 washer (0.8 mm / 0.032”) **
C
AN3 washer (1.6 mm / 0.064”) **
D
AN3 castle nut
E
Split pin
F
Friction disc
Refer to paragraph 16 for hardware designations
** (Note: thickness of these washers may be varied to
accommodate throttle lever friction adjustment)
NOTE: Throttle cables not shown for the sake
of clarity. Throttle lever detent mechanism not
shown.
BRAKE
THROTT
LE
Summary of Contents for Sling 4
Page 1: ......
