21
22
U
ser Manual
U
ser Manual
How To Use The
Hand-Held Steamer
Make sure that the H2O X5
®
appliance is unplugged.
1. Fill the water tank with water. Please refer to the
“How to use the H2O X5® Steam Cleaner” section in
this manual. Attach either the round nylon brush or the
round brass brush as explained in the “How to
assemble hand-held Steamer” section in this manual.
2. Select one of the following steam regulator positions:
To avoid streaks and puddles select the appropriate
setting for which you will be using the H2O X5
®
appliance.
For less steam use settings 1 and 2, for more steam
use settings 3 and 4.
1 – Low, 2 – Medium, 3 – High or 4 – Hot Spray.
You can change the steam regulator position and the steam output while
operating the H2O X5® appliance.
3. Once the unit has been fully
assembled and filled with water, plug
in the power cord into a grounded
electrical outlet. RED light - power
indicator will indicate when power is
on. Power switch ( O / I is in the
OFF ( O ) position (higher position).
Wait for the ready-to-use indicator
to turn green - approx 20 - 30 secs.
GREEN light will turn on when the
steam mop is ready for use. When
the ready-to-use indicator light turns green press the power switch
( O / I ) to the ON ( I ) position (lower position). The hand-held
steamer will start emitting steam. To stop emitting steam, turn OFF the
unit by pressing the power switch ( O / I ) again. If the power switch
( O / I ) is pressed (lower position) prior to the ready-to-use light
indicator turning green, water from previous use will not be heated and
!
CAUTION
OFF (O)
Position
(Higher)
ON (I)
Position
(Lower)
Red - Power ON
Green - Ready to use
will be forced out by present steam. This may also happen if the
power switch ( O / I ) was left in the ON ( I ) position (lower position)
after previous use and the unit was disconnected by unplugging only.
Make sure to turn the unit off after each use and then disconnect from
the electrical outlet so the unit is in the OFF ( O ) position when used
next time.
4. Slowly pass over surfaces to be cleaned. Apply steam liberally. Keep a
towel handy and wipe away any excess water that may accumulate.
5. When the hand-held steamer stops emitting steam, simply turn OFF
and unplug the unit, refill the water tank and continue cleaning.
To sanitize your work surfaces, kitchen countertops, sinks, bathrooms,
etc., use the hand-held steamer over the same area for about
15 seconds.
Do not carry out this procedure on heat and steam sensitive surfaces. The
force and heat of the steam may adversely affect certain materials. Always
check the suitability of using the steamer on a particular surface by first
testing a hidden area.
Never direct steam towards people, animals or plants.
• Do not use the steam to clean frozen windows.
• Be careful when using the steamer on glass, as it may break.
• Do not use steamer on leather, wax polished furniture or waxed or
unsealed floors, synthetic fabrics, velvet or other delicate steam-
sensitive materials.
Steam or water discharged from the safety pressure release valve can be
very hot. At all times during use, always make sure to keep body parts
clear of the safety pressure release valve to avoid being burned by hot
steam or water in the event of discharge.
Thane Direct and its affiliated companies assume no liability for personal
injury or property damage resulting from the misuse of the H2O X5®
appliance, including the failure to comply with the instructions contained in
this User Manual or provided by the manufacturer or distributor of the
treated surface.
NOTICE
NOTICE
!
WARNING
