Up-to-Pause Feature
The Up-to-Pause feature allows you to have control of your steam emission. By simply standing the unit upright to pause the steam, or tilting it
back down to resume the steam and continue cleaning, you decide when and where to steam. Perfect for moving objects out of the way without
having to fully shut the unit down.
Steam will emit any angle.
- Steam emission will begin and continue
at any angle shown in Fig. 1, steam
will pause when upright (90°) or lying
down (0°).
DO NOT LEAVE UNIT UNATTENDED IN THE UP-TO-PAUSE POSITION!
•
While in the Up-to-Pause position the unit continues to produce heat and draw energy.
•
Do not leave the unit in the Up-to-Pause position for longer than 5 minutes.
•
If the unit is going to be left unattended, fully shut the unit off by pressing the Power Switch to OFF (O).
•
A unit left unattended by an adult may be accidentally knocked out of the Up-to-Pause position and start emitting steam. This
may result in damage to the unit, floor or surrounding area, and/or bodily injury.
HOW TO USE YOUR H2O X2™ APPLIANCE
6
!
CAUTION
1. Put the unit into the upright and locked position.
2. Press the Power Switch to OFF (O).
3. Unplug Power Cord from the electrical outlet.
4. Make sure to remove the Mop Pad/Cloth before storage. Allow it to cool down and carefully remove the cloth.
5. Always empty the Water Tank at the end of each use.
6. Drain left-over water or steam before storing.
7. Wrap Power Cord around Upper and Lower Cord Wrap.
8. Wipe all surfaces of the H2O X2™ appliance with a soft cloth.
9. Store in a protected and dry area.
AFTER USE
5
To fill the Water Tank:
Ensure that the H2O X2™ appliance is unplugged. Turn the Water Tank cap to the “OPEN” position and remove the cap. Angle the mop and
add water by using the measuring cup. Do not overfill. Tank capacity is 300ml/10.1 oz. Replace the Water Tank cap and turn to the “CLOSE”
position.
Note:
Never put cleaning detergents into the Water Tank. Unless approved by the manufacturer, do not put any scented products in the Water Tank.
The H2O X2™ appliance uses tap water, but in areas with hard water use distilled water for better performance.
HOW TO USE YOUR H2O X2™ APPLIANCE
45º
300ml
10.1oz
300ml
10.1oz
300ml
10.1oz
300ml
10.1oz
MAX
MAX
To start using the appliance:
Once the appliance has been fully assembled and filled with water, turn the unit ON as follows:
1. Put the appliance into the upright position with the handle in its upright and locked position.
2. Plug the Power Cord into a grounded electrical outlet. Press the Power Switch to ON (l). Red Power Indicator Light will turn on indicating that
the power is on.
3. Wait for approximately 20-30 seconds for the appliance to heat up.
Note:
If the H2O X2™ appliance is taken out of the upright and locked position prior to waiting 20-30 seconds, water from the previous
use will not be heated and will be forced out by steam and will cause puddling. This may also happen if, after the previous use, the appliance
was unplugged before first turning the Power Switch to the OFF (O) position. Make sure to turn the appliance OFF after each use and then
disconnect it from the electrical outlet.
4. Tilt the handle back toward you, taking it out of the locked position.
5. Steam will begin to emit and the mop is ready for use.
6. The H2O X2™ appliance continues to steam through various angles as seen in Fig. 1.
7. To start cleaning slowly pass over the surface to be cleaned. The absorbent mop cloth picks up the dirt loosened by the steam. Apply steam
as needed to the surface. When the H2O X2™ appliance stops producing steam, press the Power Switch to OFF (O), unplug it from the
electrical outlet, refill the Water Tank and repeat Step 1 - 6.
8. To fully shut down the unit, press the Power Switch to OFF (O). Red Power Indicator Light will turn off, indicating that the power is off. Then
unplug the Power Cord from the grounded electrical outlet and put the unit in the upright and locked position.
9
.
To temporarily pause steam emission, leave the unit in the upright and locked position and use the Up-to-Pause feature.
NO STEAM
STEAMING
Fig. 1.
90°
0°
Summary of Contents for H2O X2 KB - 016
Page 1: ...Model KB 016...
