34
Parts Needed
AIR+WATER power
|
MODEL 11 Helicopter
Assembly Notes
1
3
4
2
5
7
9
6
8
10
x17
x29
x 1
x 1
x 1
x 1
x 1
x 1
x 1
x 1
x 1
x 1
x 1
x 1
x 1
x 4
x 2
x 2
x 2
x 4
x 2
x 2
x 2
x 2
x 2
x 2
x 2
x 2
x 2
x 2
x 2
x 2
x 3
x 3
1.
Unscrew the original cap of the pressur-
ized air+water tank before starting the
assembly. The original cap will not be used
in this model.
2.
The gears should mesh well with each
other in order to operate smoothly.
3.
Leave a 1 mm gap between the axle lock
and the long frame so that the wheel can
turn smoothly.
4.
Note that the sprockets must be aligned
so that the chain can operate smoothly.
5.
Cut Tube A to get tubes of the following
lengths for this model.
Tube A :
9.5 cm x 1, 30 cm x 1, 44 cm x 1
Helicopter
Tube A
1
2
3
4
5
(Note: Gears shown
here may differ slightly
from those in the kit.)
