2-14
Installation Guide 84464 Rev. B
DC Power Connection
Installations using the DC power cable (PN 855024-020) should use the red and black primary
power wires as well as the yellow remote wire as the ON/OFF switching source. The BDU will
turn OFF with the vehicle’s ignition switch when the yellow remote line is connected, so it is
important to make that connection in the vehicle (see Figure 2-11).
Figure 2-11 24V DC Power Connection
1.
Connect the RED (+) cable to the positive terminal of DC power source.
2.
Connect the BLACK (-) cable to the negative terminal of DC power source.
NOTE
Extra care and consideration must be taken when powering any
device from a dual battery 24V DC system. It is important that
24V systems use the correct GND scheme that ensures unit is
connected to the system’s lowest potential (usually chassis
GND). Otherwise damage to the BDU and antenna are likely and
could void the warranty.
Summary of Contents for VesseLINK
